Electric Dog Fence Installation Driveway

Make sure the dog fence wire is laying in the bottom of the groove and not sticking out.

Electric dog fence installation driveway.

It should take about an hour for the 1 st and 2 nd steps. Plan your system layout. This is the most important step. You may also choose to tunnel underneath the driveway.

You will spend about 4 hours to bury the wire if you use a trencher or edger. A transmitter plugs into a standard outlet and emits a signal that travels along underground wires. Often the solution is easy. Using high tech pet ultra wire will give you and improved underground fence installation compared to typical electric dog fence wire.

Secure the wire to the bottom of both holes using dog fence staples. Crossing the driveway will take about an hour. It is a good idea to set aside about 10 hours to get your installation completed. Electronic pet containment is a dog training system that that uses a small electric charge to keep your dog in the yard.

You can insert the wire in an existing expansion joint or you can cut a slot with a circular saw that has a masonry blade. A hidden boundary is created and a receiver on your dog s collar sounds a warning tone when the dog wanders near the boundary. Be sure to take the time to plan carefully. Use a hand shovel to dig a 10 12 inch hole on each end of the groove where the driveway meets the grass.

Place the wire in the trench and fill. Push the dog fence wire down into the holes on both ends of the pathway.